Plumbing services in Paphos
Bathroom plumbing in Paphos
A new bathroom is only as good as the pipework behind the tiles. We handle the plumbing for bathroom renovations and new installations across Paphos: concealed mixers and valves, shower drainage, wall-hung frames, toilets and basins, all installed so the finish lasts and nothing leaks into the room below.
What is included
- Concealed mixers and valves
- Shower drainage installed to last
- Wall-hung frames and basins
Getting the hidden work right
Most of the bathroom problems we are called out to are not caused by the tap or the toilet itself, but by what was done behind the wall. A concealed mixer set at the wrong depth, a shower drain without enough fall or a joint that was never tested will show up months later as a stained ceiling downstairs or tiles that have to come off. In Cyprus, where hard water quickly scales up valves and cartridges, being able to reach and service those parts later matters just as much.
What we install
- Concealed thermostatic and manual shower mixers
- Walk-in and level-access shower drains, both linear and point drains
- Wall-hung toilet frames and concealed cisterns
- Basins, vanity units and wall-hung sinks
- Isolation valves so each fixture can be serviced without shutting off the house
- New supply and waste pipework where the old layout no longer suits
How a bathroom job runs
We start by looking at the room, the existing pipework and the layout you want, and agree what goes where before any wall is opened. On a renovation, we do the first fix once the room is stripped: supply and waste pipes, concealed mixer bodies, frames and drains, all pressure-tested and checked for fall. Your tiler then works around an installation that is already tested.
Once the tiling is finished, we return for the second fix: fitting the trims, toilet, basin, taps and shower set, then running everything and checking every joint for leaks. If you are working with a builder or tiler, we coordinate the timing with them.
Before you start and how to get in touch
Where possible, choose your mixers, toilet and basin before the first fix, as concealed parts and frames must match the products that go on later. Keep the installation sheets that come in the box. Then call us, send photos of the room and the products you have chosen on WhatsApp, or use the online form, and we will get back to you about the plumbing side of the project.
Frequently asked questions
Do you do the tiling as well?
We focus on the plumbing: supply and waste pipes, concealed mixers, shower drains, frames and the final fitting of sanitaryware. We are happy to work alongside your tiler or builder and coordinate the timing, so the pipework is installed and tested before they close the walls and lay the floor.
Can I convert my bath into a walk-in shower?
In most cases, yes, but the drain is the deciding factor. A level-access shower needs enough depth and fall in the floor for the water to drain away properly. We check the existing waste pipe and the floor build-up first, then suggest the type of drain and tray that will actually work in your bathroom.
Why does my shower mixer drip or lose temperature?
Mixers are sensitive to limescale and to unbalanced hot and cold pressure, both common in Cyprus homes where hot water comes from a roof tank and cold water from the mains or a pump. Cleaning or replacing the cartridge, and sometimes balancing the supply, usually solves it. This is also why the installation depth of a concealed mixer matters.
Should I buy the fittings myself?
You can, and many customers choose their own toilet, basin and shower set. Let us know what you have chosen before the first fix, ideally with the model details or installation sheet, so the concealed parts, frame and pipework are set up for those exact products and nothing has to be adjusted after tiling.
Need this job done?
Call us or send a photo on WhatsApp. One photo is usually enough for us to see the problem and tell you what the repair involves.